Jpdiag

This problem has now been solved!

I have tried jumping the starter solenoid and the engine turns.
There is no signal going from the ECU to the starter solenoid.
The wiring from the ECU to the starter is good.

I have tried many other software versions for both 59M and 5A (both HW103 and HW610) but none appear compatible in Diag as ...

I'm going to send you a PM about this, as I think there's a bit more going on!

The immo light stays on after key-on, so the dash thinks it is immobilised!

Thanks JP, I didn't check for the immo box as I though they were only on the S4s and ST range.

I'll have another look and see what happens. I may also disconnect the clocks as I have had other bikes running without them connected, a popular mod in the Desmo Due Race Series where they remove the ...

Hi

I am trying to turn the immo off on an IAW59M with S16DG118 for a M620.
I am using writer v314c and after writing, Diag gives me the usual "ECU Stored" when checking immo status.

However, on the bike the immo light stays on and the bike will not start.

This is not the first time this has ...