Ducati Streetfighter V4 S 2023 Euro 5 - Bike not recognized 4F00

[gigibrum_v4s]

Hello,

I’m using MelcoDiag with a known-good original ELM327 v1.4 USB interface (bough off of Amazon amazon.it/dp/B0F7S1W31Z). Communication with the bike works correctly, but MelcoDiag does not recognize the bike.

Bike: Ducati Streetfighter V4 S 2023 Euro 5
Detected bike code: 4F00
MelcoDiag message: “Bike not recognized: 4F00”
Estimated: Scrambler (bike=3)

Interface: ELM327 v1.4 USB
MelcoDiag version: 2.0.5.0
VIN: ZDM4F00*********
Communication seems stable

I have not attempted service reset or throttle/RBW procedures because even the mileage is not red correctly and I don't want to brick my ECU

Could anyone please confirm whether this ECU/model is supported, or whether the 4F00 bike code can be mapped correctly?


I'm pasting here diagnostic info/log (the complete VIN is masked):

Code: Select all

"File generated On 26/06/2026 11:46:39"
"Software version 2.0.5.0"
"ELM version : ELM327 v1.4"

"Auto Detect Bike = Scrambler ?"
"User Bike = 2023"

"CAN Bike = "
"Ecu = N/A"
"Hardw = N/A"
"Softw = N/A"
"OilService = YES"
"DesmoService = NO"

"
14 PIDS active founds

018_0002A00040004D96  
019_9609600000030D86  
080_202226C005200F87  
020_0041511000004BFE  
08A_0000000000000D8B  
100_0012017017000E37  
320_4A61711859888D2E  
220_0000400000000D14  
174_F47F0055918501E3  
178_FA7F022E796601F5  
17C_F67F0100EF8F01D2  
330_3468591599AB0CA8  
024_000000000000000A  
180_C00035004444455E  
"
"Vin = ZDM4F00AAPB000907"
"DTC = "
#ERROR 448#
"Bike = 3"
"lic not found
PaniVIN: ZDM4F00*********
"
"not registered"

Please note that I saved the debug log file before activating the license, of course I already activated the license but it didn't change anything.

Thanks.

[jpl250rs]

thanks
it's patched you can redownload.
don't expect to see reliable data in the first menu , it's not coded yet ,
and it's safe do not worry

[gigibrum_v4s]

Thank you very much!
I just connected the bike but I was not able to reset the service light. I tried "Service reset", then "Annual service 0", then "Annual service 1" but none of these turned the service light off although the service date value is correctly set to today.

Thank you again for your support.
Do you think it'll be safe to also do TPS and APS resets?

[gigibrum_v4s]

I'd like to help if I can, I also have several developing tools (both hardware and software). Let me know how any of this might be helpful

[jpl250rs]

euro 5 seems an other protocol , i'm just starting to dig into it with the help of cyclingdude723

[gigibrum_v4s]

I think so. Again let me know if you guys need any help. I don’t have a lot of experience in ecu mapping but I do have professional experience with canbus, firmware and software engineering