Jpdiag

yes for the missing data i suspect the elm v1.5 compatibility
if you havent bought it from an official shop , that can be the issue
for the registration , you haventdo the things correctly . "lic not found"
don't change the name cle(1).lic is not the same as cle.lic for example

hi ok some progress the file was named incorectly now saying registered but when i click desmo service lights flah asnd get a tone but when i turn the ignition on desmo is still showing the overdue service
"Hardw = N/A"
"Softw = N/A"
"OilService = YES"
"DesmoService = YES"

"
8 PIDS active founds

020_0700FF03AC004100
080_00118410000000C8
024_05BC068C00000000
022_0000000000010000
018_00004A0000000002
160_C8C800006564CCCC
150_0000545058500006
100_4012283F8141D800
"
"Vin = ZDMB200AADB005295"
"DTC = "
"5682832F"
"Bike = 3"
"lic found
? outp='ZDMB200AADB005295'
PaniVIN: ZDMB200AADB005295
lic is valid
? outp='ZDMB200AADB005295'
PaniVIN: ZDMB200AADB005295
lic is valid
"
"registered"

Hi just one point I am using a wireless Lonelec adaptor could this be the issue?

lonelec should be ok .
we need a remote session again to check this

Cool no problem are you free Friday at all or tomorrow afternoon after 3pm?

we can try to meet tomorrow afternoon

Ok cool will get on here and drop a message about 3pm many thanks

aAll set up if you want to dial in

ok send me id and pass

hi for logging in here