Jpdiag

Hi everyone,
I'm trying to connect melco to my multistrada 1200s y2011 without success.
I've bought the cable "AMHTDOL VAG KKL 409.1 USB Chip FTDI FT232RL" and the adapter "3 pin a 16 pin OBD2 fiat with clip" these are the links:
https://www.amazon.it/dp/B0F6VK4NQS?ref ... b_ap_share
YACSEJAO Adattatore da 3 pin a 16... https://www.amazon.it/dp/B0CQLWG14V?ref ... b_ap_share

The program is tested on two different notebook with win 10 and connecting the bike with the program seems to have some problem with com/speed. I've verified the com number and it's the right one.
Do you have any experience on that?

Thank you
Giuseppe

Kkl cable works only with Jpdiag

Your bike need melcodiag , and melcodiag works only with an elm interface

Thank you jpl250rs, I already have an elm interface but Bluetooth, I need an USB one? Another question, for the connection bike-elm is it good the one I already have? This one: https://amzn.eu/d/3wyxuMd

Thank you again for the support

the bluetooth one is ok.
you need to attache a serial comport to it and use it as a serial one