Jpdiag

HI , having had no end of problems getting a licence and then not being able to register, I decided to try a new installation in a totally seperate file, and had instant success.
Not sure if it's a new update, or the fact that i was running melco diag from a different folder , but I Got a licence on the first attempt , installed it and it cleared the "get licence" box straight away, I t struggled to read any fault codes but did reset my desmo service light on the first try.
less than 20 minutes from start to finish
So many thanks, and i'll put a couple of $ on your paypal.

"File generated On 06/10/2025 18:35:12"
"Software version 2.0.4.8"
"ELM version : ELM327 v1.5"

"Auto Detect Bike = MTS 1260"
"User Bike = MTS 1260"

"CAN Bike = "
"Ecu = 286.4.279.1CUUUUU"
"Hardw = "
"Softw = 10SW046861U"
"OilService = NO"
"DesmoService = NO"

" vin CD9509C6
vin DATA
vin *********
vin *********
vin *****
vin ********

12 PIDS active founds

080_1AD2BCC030200F3A
100_C712040041000F82
020_00009B0000004653
174_F57F0000C16A0CD0
178_F57F0321A57F0C3A
17C_00000000CA950C25
022_000000000003F4D5
023_000000FC7FA304C4
188_80037FD38063447F
018_0002A00085004670
019_9609600000000780
024_000000000000000A
"
"Vin = *************************"
"DTC = "
"D22DF08C"
"Bike = 2"
"lic found
***************************
"
"registered"

Thank you for the confirmation
So desmo ok on 10sw