Jpdiag

When pressing the oil service reset Melcodiag hangs and has to be killed forcefully. Reset fails. Report below.
Also, same when doing Desmo reset, but here the rev counter briefly goes up to 1k rpm and then program hangs. However it seems to have done the reset. This was not the case with earlier version. Any clues for the oil reset?

"File generated On 2026-04-15 14:55:03"
"Software version 2.0.4.8"
"ELM version : ELM327 v1.4b"

"Auto Detect Bike = "
"User Bike = MTS 1200s 2014"

"CAN Bike = "
"Ecu = MELCO HIMEJI "
"Hardw = J001"
"Softw = 00000304"
"OilService = YES"
"DesmoService = NO"

" vin DATA
vin DATA
vin 21a907F1A31
vin DATA
vin DATA
vin DATA
vin DATA
vin DATA
vin DATA
vin DATA
vin DATA
vin 7F1A12

16 PIDS active founds

022_0000000000000000
240_C170E000002AAF00
150_113C123C3D3B022C
020_02000048D6010000
080_020102000005DCC8
018_0000420000000004
160_C8C8616561650A13
024_BE2E9CB200000000
210_0000000000000000
300_A60984008A492940
230_0000000000080000
110_0032580440000E10
190_3C00737D00FFFC4C
120_8B26010037A5010A
200_0000000000000000
100_C304707D8E35E003
"
"Vin = "
"DTC = "
"BAC94AC3"
"Bike = 7"
"lic found

"
"registered"

the hang problem will be resolved. not all elm give same acknolegde , now it'll be handle in future release