Jpdiag

Hello everyone. Got this to help change service dates on 2018 Scrambler 1100 Sport and 2022 Multistrada V4S.
Tried it on the scrambler and the reset buttons do not do anything when pressed and service light still on. Made sure all the program files were not locked. ELM327 v1.4 I can post a copy of the debug report to get idea how to get this to work. Thank you

did you register the 2 bikes ?
yes the report would help to understand your issue

I only did the 2018 Scrambler to start with, The following is the debug file

"File generated On 8/21/2026 6:03:07 PM"
"Software version 2.0.5.3"
"ELM version : ELM327 v1.4"

"Auto Detect Bike = Scrambler 1100"
"User Bike = 2018"

"CAN Bike = "
"Ecu = N/A"
"Hardw = A2C9295020099"
"Softw = QD1E0010"
"OilService = YES"
"DesmoService = YES"

"
13 PIDS active founds

100_C8121140000009DA
174_EF7F00009B9407B4
178_E17F01123A810777
17C_000000001A9707CA
018_0002A00020C04EC2
019_9609600000000E75
020_0040301000000539
022_000000000003F0A1
023_0000005480230094
024_0000000020000AE8
080_1FC1FC0305000AE9
150_0003107900024536
188_7FDB7F0F7FA74046
"
"Vin = ZDMKAFCP6JB001259"
"DTC = "
"AA4FC8F9"
"Bike = 9"
"lic found
? outp='ZDMKAFCP6JB001259'
PaniVIN: ZDMKAFCP6JB001259
lic is valid
? outp='A2C9295020099'
***read annual***
021003
0250030000000000

>
031a9200
065A920026082100

>
***read annual***
021003
0250030000000000

>
031a9200
065A920026082100

>
hard :
soft :
? outp='ZDMKAFCP6JB001259'
PaniVIN: ZDMKAFCP6JB001259
lic is valid
? outp='A2C9295020099'
"
"registered"

registration is ok
did you try this trick viewtopic.php?p=3540#p3540 ?

The shots of the bike screen in the link are from a Multistrada I think and not Scrambler like mine. I tried and still no luck

if you try to connect with m3c ticked , you got no serial number instead of VIN ?

with the mc3 ticked the screen does not show anything like ecu type hardware, software version and vin all blank.
When any bike is ticked it then shows hardware software and vin but ecu type show N/A