Hello,
my computer makes contact with the bike. But after that it doesn't seem to work. I can't get DTC, can't reset service or reset the dash pin etc etc.
Do i do something wrong or is there an other problem? My bike is 2017 and not 2016 as i suggested when i bought the licence.
File generated On 3-7-2025 19:55:59"
"Software version 2.0.4.4"
"ELM version : ELM327 v1.5"
"Auto Detect Bike = MTS1200 ENDURO"
"User Bike = 2016m"
"CAN Bike = "
"Ecu = "
"Hardw = "
"Softw = 10SW041702U"
"OilService = YES"
"OilService = NO"
"DesmoService = YES"
"DesmoService = NO"
" vin DF930E3B
vin DATA
vin 135A905A444D414130334141474230313437343255
vin 7F1A1255555555
vin 7F1A1255555555
vin 0C5A953130535730343137303255
12 PIDS active founds
024_0000000000000759
080_1C800000302007A6
100_C712033035000740
018_0002A00082006BFC
019_9609600000000C4F
174_00800000CC6A0429
178_0B800125F07504DA
17C_00000000D59304E6
022_000000000003FE07
023_000000FC7FD70E10
188_80077B13801F4EE0
020_0000950000004645
"
"Vin = ZDMAA03AAGB014742"
"DTC = "
"6EA5C25A"
"Bike = 2"
"lic found
ZDMAA03AAGB014742
"
"registered"
Problems multistrada 2017
Forum rules
Do not send PM , if your can't find your problm , please open a new thread with your bike and issue
Do not send PM , if your can't find your problm , please open a new thread with your bike and issue
Re: Problems multistrada 2017
the software 10SW cannot be reset at the moment
but you shall be able to read /delete DTC
do not scan for ecu ,click directly on dtc button 1st
if still nothing , scan for dtc , hopping your elm is able to switch between each of them , you click on result ex : 7e3 , then dtc button to access this ecu
you have to do it for each item returned by the scan
but you shall be able to read /delete DTC
do not scan for ecu ,click directly on dtc button 1st
if still nothing , scan for dtc , hopping your elm is able to switch between each of them , you click on result ex : 7e3 , then dtc button to access this ecu
you have to do it for each item returned by the scan