Jpdiag

I used the Melcodiag for Mitsubishi ECU
ON:
2016 Ducati 1299 base
I cleared the service codes. I clicked on the “MAP” button and now bike wont start. Did I remove the engine map on the bike by mistake?

Any suggestions how this can be restored?



Thank you!

map button is for relearn map sensors , it has nothing to do with the mapping.
you can try to reset the bbs/ecu disconnecting the battery for few minutes , and check if the bike back to life.
no error codes stored?

MAP = Manifold Absolute Pressure
Just to clarify
Best Regards