Jpdiag

Hi there. I have managed to get my bike to talk to Melcodiag and I have registered the software. Unfortunately, I am not able to reset my service indicator. Has anyone achieved this with the 2018 Scrambler 1100?

Here is the report read-out:

"File generated On 26/07/2026 13:17:29"
"Software version 2.0.5.1"
"ELM version : ELM327 v1.5"

"Auto Detect Bike = "
"User Bike = Ducati Scrambler 1100 2018"

"CAN Bike = "
"Ecu = N/A"
"Hardw = "
"Softw = "
"OilService = YES"
"DesmoService = NO"

" vin:NO DATA>

12 PIDS active founds

018_0002A00020C04BAB
019_9609600000000B1C
024_00000000000008E2
080_1DA1DA03050008B1
188_7FEF7C1F804B4B04
022_000000000003FB6E
023_000000547FA70BB1
174_06800000A493021C
178_E77F090F138702D6
17C_00000000AD96028D
100_C812110000000853
020_0040301000000FEB
*ECU found TX:7E0 RX:7E8
*ECU found TX:7E1 RX:7E9
*ECU found TX:7E2 RX:7EA
*ECU found TX:7E3 RX:7EB
"
"Vin = "
"DTC = "
"EA79B5B9"
"Bike = 4"
"lic found
hard :
soft :
***read annual***
021003
0250030000000000

>
031a9200
065A920026072600

>
"
"registered"

Thanks in advance for any help.

Mart

seems strange you'r not getting the vin
where you elm is coming from ?
did you try to tick m3c before to connect ?

I hope the link works. It was from Amazon: https://www.amazon.co.uk/Diagnostic-PIC ... 1785072625

I used m3c for the report but it got my VIN for registration by clicking 'Any bike'. No VIN with m3c.

It gives annual service date as today's date. Buttons seem active but no response.