Hello jpl250rs,I am trying to register MelcoDiag for my bike, but I am getting the "serial empty" error. The program reads the VIN but leaves the ECU fields completely blank due to my interface limitations.
Here is my setup details:
Bike: Ducati Streetfighter V4S (2023 / Euro 5)
VIN: ZDM4F00AAPB001170
MelcoDiag Version: 2.0.4.9
Interface: USB ELM327 v2.1
Here is the exact content of my generated debug report:text"File generated On 18/05/2026 18:10:25"
"Software version 2.0.4.9"
"ELM version : ELM327 v2.1"
"Auto Detect Bike = If your bike is not a 2010 to 2012 made ,please contact jpl250rs with your VIN and model bike"
"User Bike = Streetfighter V4S 2023"
"CAN Bike = "
"Ecu = "
"Hardw = "
"Softw = "
"OilService = NO"
"DesmoService = NO"
" vin 45A8F035A444D3446303041415042303031313730
2 PIDS active founds
"
"Vin = ZDM4F00AAPB001170"
"DTC = "
"0C44DC6E"
"Bike = 1"
"lic not found
ZDM4F00AAPB001170
"
"not registered"
Could you please help me generate the cle.lic file for my motorcycle?
Thank you very much for your time and help!
Best regards.
"Licence Request"
Forum rules
Do not send PM , if your can't find your problm , please open a new thread with your bike and issue
Do not send PM , if your can't find your problm , please open a new thread with your bike and issue
Re: "Licence Request"
i'mnot sure this will be sufficent.
and not sure your elm is fully compliant and
the v4 is not support yet for the reset
and not sure your elm is fully compliant and
the v4 is not support yet for the reset