Jpdiag

Hello,

My software was previously unlocked, it’s been awhile but I had to get a new laptop and I’ve upgraded the ECU on the bike to a Corse.

I’m connecting fine and reading fine but can’t do anything as the software isn’t licensed to this ecu, back when I registered it was for only one bike.

I’ve submitted through the website twice now waiting a week each time and I have not received an email for license. Yes I’ve been watching my junk mail like a hawk.

Any help would be greatly appreciate.

T

can you post a debug report ? i don't find any data from you except those in 2014

Hello,

I'm not seeing where to run a debug report, this is the only log I can get

: 32A0A0PD004
: IAW5AMHW610
: 00
:
: 0000
:
: 00 00 00 00 00
: DUC
: 20 13 06 05
: 7F9C1WD5N
: 7F9C1WD5N

you can run a report with melcodiag only

Hi there,
I have got a licence recently for MONSTER 696 2009 bike, with the ECU S180040101 A and serial number 285327289. I copied the "cle.lic" file into the JPDIag's folder and nothing happens (I use Windows 10 x64 as my environment, no virtualization). I still able to run JPDiag, connection with my bike is okay and I can see its IDs but there is no licence have been seen by the software. Could anyone help me please?
thanks!

have yo done the tests in this post viewtopic.php?t=5 ?

yes, I did.
I've tried to do the same stuff on Windows 7 platform and still having the same issue. Please look at attached picture
Thanks!

P.S. I have the siemens-continental ECU

you can give melcodiag a try selecting m3c ecu.
then you can register from there if the lic is still not recognized

the old m3c9 software is not supported anymore

Got it! The license didn't work for me with Melcodiag. I've made a new request for it! Many thanks for your help
P.S. Melcodiag has been working with the new license very well! Many thanks to author.