Jpdiag

**I found and fixed the problem. The cause was a seized exhaust valve.**

**During the inspection, I removed the valve cable, and after switching the ignition on, I read a servo motor fault with MelcoDiag. The fault was successfully cleared. The diagnostics are working correctly: faults can be read ...

Thank you very much, I'll check it out. I also think my exhaust flap is stuck. But thank you very much.

Thank you very much, I'll check it out. I also think my exhaust flap is stuck. But thank you very much.

There are no errors in the system. I'm trying to figure out what could be causing this. This morning, when I start the bike cold, only the lower exhaust pipe works during warm-up, while the upper pipe doesn't seem to be working. I warm the bike up for a long time, to about 80 degrees Celsius, but ...

The new version of Melсodiag works more reliably than the previous one. But I'd like to find more information about resetting the TPS, APS, and everything else. The Desmo and service oil reset works fine, and I also managed to reset the PIN.

If you need more information, I can experiment on my ...

Thank you very much. Could you please check if I did it correctly? Can you tell me where the algorithms are described? Or is it different on all motorcycles? Does the TPS H indicator tell me if the value should change?
Снимок экрана 2026-04-03 190746.png
"File generated On 03.04.2026 19:11:48 ...

I did the same as you said. I don't understand why it's not supported?

Thanks for the quick reply)
New log
"File generated On 02.04.2026 21:01:39"
"Software version 2.0.5.0"
"ELM version : ELM327 v1.4"

"Auto Detect Bike = MTS1200S 2013"
"User Bike = 2013"

"CAN Bike = "
"Ecu = MELCO HIMEJI "
"Hardw = N/A"
"Softw = "
"OilService = NO"
"DesmoService = NO"

"
0 PIDS ...

Hello. Could you please tell me if there should be a sound when resetting the TPS? When I check for errors, it sees three blocks, but when I try to query one of the blocks, it says "No Answer." Is this how it should be?

"File generated On 02.04.2026 18:25:39"
"Software version 2.0.4.9"
"ELM version ...